Board index » Setup And Technical




Post new topic Reply to topic  [ 12 posts ]  Go to page Previous  1, 2
Author Message
 Post subject: Re: Weak Bridge pickup on my 330... please help
 Post Posted: Wed Oct 19, 2011 8:23 am 
Offline

Joined: Mon Mar 21, 2011 10:55 am
Posts: 16
Is this solder joint you speak of inside the pickup where I'd have to take the tape off? Or is it just on the bottom? Cause I remember seeing a solder joint on the bottom side.


Top 
 Profile  
 
 Post subject: Re: Weak Bridge pickup on my 330... please help
 Post Posted: Wed Oct 19, 2011 11:49 am 
Offline
Site Admin
Site Admin

Joined: Mon Aug 08, 2005 1:00 pm
Posts: 4019
Location: Santa Ana, CA
It's the brass pins on the bottom. But it's the solder joint inside the coil I'm thinking is the problem. Heat the pins up with your iron so that the solder will reflow inside the coil. You can also take the tape off and get to the outside end of the coil winding and reflow it there.

Heat could certainly damage the pickup but, as I said, it doesn't seem like you have much to lose by trying. If it works, you won't have to replace it!


Top 
 Profile  
 
Display posts from previous:  Sort by  
 
Post new topic Reply to topic  [ 12 posts ]  Go to page Previous  1, 2

Board index » Setup And Technical


Who is online

Users browsing this forum: No registered users and 2 guests

 
 

 
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  

Register    Login    Forum    Search    FAQ
X