|Rickenbacker International Corporation - Forum|
|shoter bridge height adjustment screws-330/6
|Page 1 of 1|
|Author:||neilcoates [ Sat May 05, 2012 11:52 pm ]|
|Post subject:||shoter bridge height adjustment screws-330/6|
Hi, I have a beautiful jetglo 330/6 , and would like to adjust the action slightly lower. However ,the bridge is lowered as far as it will go , with no more adjustment possible , as the compression springs are now fully compressed.
Could I just replace the bridge screws with ones that are say 1/8" shorter?? If so what is the thread and spec I would need?? Anywhere sell these with the same cap head??
|Author:||neilcoates [ Sun May 06, 2012 1:58 am ]|
|Post subject:||Re: shoter bridge height adjustment screws-330/6|
ignore my last post on this subject!! Getting mixed up on my screw direction . Of course I can lower the bridge. It was raising it when I had the fret buzz that made me reach the end stop and compress the spring fully!.Just need a little tweak!!Hopefully the fret buzz will still be gone!
|Page 1 of 1||All times are UTC - 8 hours|
|Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group|