| Rickenbacker International Corporation - Forum http://www.rickenbacker.com/forum/ | |
| shoter bridge height adjustment screws-330/6 http://www.rickenbacker.com/forum/viewtopic.php?f=2&t=15091 |
Page 1 of 1 |
| Author: | neilcoates [ Sat May 05, 2012 11:52 pm ] |
| Post subject: | shoter bridge height adjustment screws-330/6 |
Hi, I have a beautiful jetglo 330/6 , and would like to adjust the action slightly lower. However ,the bridge is lowered as far as it will go , with no more adjustment possible , as the compression springs are now fully compressed. Could I just replace the bridge screws with ones that are say 1/8" shorter?? If so what is the thread and spec I would need?? Anywhere sell these with the same cap head?? |
|
| Author: | neilcoates [ Sun May 06, 2012 1:58 am ] |
| Post subject: | Re: shoter bridge height adjustment screws-330/6 |
ignore my last post on this subject!! Getting mixed up on my screw direction . Of course I can lower the bridge. It was raising it when I had the fret buzz that made me reach the end stop and compress the spring fully!.Just need a little tweak!!Hopefully the fret buzz will still be gone! Doh!!! |
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ | |