As I understand, the "tunnel" connecting the tailpiece cavity and the electronics cavity in a Rick bass (don't know about the guitars) is used for the grounding, shielding or earthing (as it'd be in german, I don't know the proper english expression)? So the tailpiece should be connected to any of the potientometers with any kind of wire?
Post subject: Re: Tailpiece shielding / grounding
Posted: Fri Aug 17, 2012 1:09 pm
Joined: Sun Oct 08, 2006 6:07 am Posts: 3726
First, you are correct. In the USA, it's commonly called "grounding," and in the UK it's commonly called "earthing."
Usually, a wire connected to either the bridge base or tailpiece bracket is connected on the other end to either the common ground of the output jack or a tone potentiometer case, which is also grounded. The goal is to get everything to one point of grounding at the jack to eliminate "ground loops," which can exacerbate hum and noise.
Users browsing this forum: No registered users and 6 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum