Rickenbacker International Corporation - Forum
http://www.rickenbacker.com/forum/

New Member - Need setup/repairs in the Omaha area
http://www.rickenbacker.com/forum/viewtopic.php?f=2&t=15634
Page 1 of 1

Author:  Prof. Rickenbacker [ Fri Oct 18, 2013 11:29 am ]
Post subject:  New Member - Need setup/repairs in the Omaha area

I'm not sure if this is the correct forum for this, but here goes.

I have a 2002 4003 that needs a set up and some soldering -- the bridge pickup, after a lot of crackling and static, is out completely. This happened years ago with my 4001, and it was a soldering issue.

I don't know enough to do either the set up or the soldering myself -- I am a very messy solderer.

Where can I take it in the Omaha, NE area to get both of these done? I want someone who has worked on Rics and understands the double truss rod.


Thanks!

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/