Board index » Setup And Technical




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: What screwdriver for 4001c64 bridge
 Post Posted: Sat Aug 26, 2006 10:40 am 
Offline
User avatar

Joined: Fri Aug 18, 2006 6:31 am
Posts: 116
Location: TX
My D & G need a slight intonation adjustment, but I can't figure out a way to get a screwdriver where it needs to go. Coming in at an angle risks stripping the heads. I assume an offset screwdriver is needed. But where do I find the right size? Or is there another method? Thanks.


Top 
 Profile  
 
 Post subject: Re: What screwdriver for 4001c64 bridge
 Post Posted: Sun Aug 27, 2006 8:35 am 
Offline
User avatar

Joined: Fri Jun 30, 2006 1:51 am
Posts: 3362
Location: Atlanta, GA
I just use a regular screwdriver. The saddle screws aren't under any appreciable torque, so damaging the heads has never been an issue for me.


Top 
 Profile  
 
 Post subject: Re: What screwdriver for 4001c64 bridge
 Post Posted: Mon Aug 28, 2006 6:49 am 
Offline
User avatar

Joined: Fri Aug 18, 2006 6:31 am
Posts: 116
Location: TX
Thanks for the tip, beatlefreak.


Top 
 Profile  
 
Display posts from previous:  Sort by  
 
Post new topic Reply to topic  [ 3 posts ] 

Board index » Setup And Technical


Who is online

Users browsing this forum: No registered users and 5 guests

 
 

 
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  

Register    Login    Forum    Search    FAQ
X