Rickenbacker International Corporation - Forum
http://www.rickenbacker.com/forum/

Broken R Tailpiece
http://www.rickenbacker.com/forum/viewtopic.php?f=2&t=3226
Page 2 of 2

Author:  DaleFortune [ Fri Sep 29, 2006 9:56 am ]
Post subject:  Re: Broken R Tailpiece

John, my main concern was for the older bronze cast(brass)
R tail pieces made in the mid-60's. These can be repaired quite easily. This was to restore and save the original tailpiece. The ones made after 1967 (i believe) were the zinc cast metal and I think it would be to the advantage of most to replace it with a new one since repairing and rechroming one costs more than a replacement one.

Author:  JohnHall [ Sat Sep 30, 2006 1:37 am ]
Post subject:  Re: Broken R Tailpiece

You're ahead of me then, Dale, because I have yet to see a brass or bronze -R- tailpiece. I've seen plenty of 60's zinc ones that were copper flashed which, before plating, LOOKED like bronze though . . . you sure that isn't what you saw? I have seen a few brass 400 series bridges but these were incredibly crude sand castings.

Anyway, I guess you can weld zinc with the right materials but as you say, it certainly isn't cost effective.

Page 2 of 2 All times are UTC - 8 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/