Rickenbacker International Corporation - Forum
http://www.rickenbacker.com/forum/

Reversing Keywinds on 4001C64S
http://www.rickenbacker.com/forum/viewtopic.php?f=5&t=15181
Page 2 of 2

Author:  aceonbass [ Mon Sep 03, 2012 1:45 pm ]
Post subject:  Re: Reversing Keywinds on 4001C64S

In addition to John's info, you will need to use the tuner bushings currently in your headstock because the #00550 tuner bushings require a slightly larger hole. Also, the C64 tuner shaft is slightly larger than the #00550 tuner shaft, which means that the shaft will be a tighter in the C64 bushing, and possibly require drilling of the bushing oversize. Remove the bushings if you have to drill them so they don't catch on the drill bit and spin in the headstock.

Author:  JohnHall [ Mon Sep 03, 2012 2:24 pm ]
Post subject:  Re: Reversing Keywinds on 4001C64S

Dane, in the tests we did before I answered his question, we didn't run into this problem. The prexisting bushing worked fine with the modern tuner.

Author:  johnallg [ Fri Oct 26, 2012 7:02 pm ]
Post subject:  Re: Reversing Keywinds on 4001C64S

DanJ wrote:
Thank you, John. I should be placing an order within the next few weeks.

If you haven't ordered yet, I can swap you a near-new "normal" RIC set for your reverse nickle set.

Page 2 of 2 All times are UTC - 8 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/