Rickenbacker International Corporation - Forum
http://www.rickenbacker.com/forum/

Paint flake near binding
http://www.rickenbacker.com/forum/viewtopic.php?f=6&t=3973
Page 1 of 1

Author:  Ciufo19 [ Wed Dec 13, 2006 6:49 am ]
Post subject:  Paint flake near binding

I recently purchased my first Rickenbacker, a FG 360/12. It got its first ding the other day; it was bumped and a small (about 3mm x 1mm) flake of the finish/clearcoat came off. This occurred on the rear side, where the finish meets the white binding. I found the flake and I think it can be reattached; I was wondering if there were any special glues, adhesives, etc., that should be used to do so. Thank you.

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/