Hi, I have a beautiful jetglo 330/6 , and would like to adjust the action slightly lower. However ,the bridge is lowered as far as it will go , with no more adjustment possible , as the compression springs are now fully compressed.

Could I just replace the bridge screws with ones that are say 1/8" shorter?? If so what is the thread and spec I would need?? Anywhere sell these with the same cap head??

ignore my last post on this subject!! Getting mixed up on my screw direction . Of course I can lower the bridge. It was raising it when I had the fret buzz that made me reach the end stop and compress the spring fully!.Just need a little tweak!!Hopefully the fret buzz will still be gone!

Doh!!!